I have a LT-1 engine that I was going to use for a turbo project, but have had a change of heart, so I'm selling.

I bought the engine from someone else who didn't know if it ran or not, so I'm telling you the same. I KNOW NOTHING ABOUT THE ENGINE, except it is complete from the fuel rail to the oil pan. (no coil or sensors) I had planned to rebuild it with a new rotating assembly, so it didn't matter if it needed rebuilding for me anyway.

I would suspect that this engine came out of an impala, because it does have steel heads. I do know that it is the 5.7, cause it has it stamped onto the back of the block beside the casting numbers.

PCM, I have one for this engine, along with the wiring harness for a LT1 and 4L60E. NO TRANNY!

I also have a set of pacesetter headers that I can sell with this engine.

ENGINE, HARNESS, PCM---$550
PACESETTER LT'S---------$150

Thanks

D Moss

 

$500 for engine, wiring harness, and PCM.

D Moss

 

If you decide to seperate parts, how much for just the ecm. ODB 1 or 2?

 

If you decide to seperate and will go 400 shipped on the engine PM me please. Thanks!

 

I'd have to sell everything if I were to seperate it...

Josh.....Where are you located?

76 meno.....OBD1 computer and what offer do you have in mind?

Thanks

D Moss