Heads/cam setup custom ordered from GTP for a boosted motor. Setup was put together about 5 years ago, and all parts have about 20K miles:

GTP stage 2+ cylinder heads. 241 castings with 2.02/1.57 valves. Heads are fresh out the machine shop and have had a thorough cleaning and inspection. They received new valve seals, performance valve job, and a few exhaust bolt holes have been helicoiled. Milled .010" Asking $1000 shipped.

GTP2 cam. Cam is a single pattern .540" lift, 222 duration on a 114LSA. Cam doctor report comes with cam. $225 shipped.

Comp Cams 7.4" pushrods. SOLD

I also have a stock 2000 38K mile shortblock for sale that was immediately pulled after I began to hear a faint rod knock. Rod and main caps have not been pulled off. Comes with all covers, cam and crank sensors - no knock sensors. No cam. $375 pick up only, $400 if you want the stand too.

Power steering pump, resevoir, pulley, bracket and all bolts. SALE PENDING

Aluminum LS1 driveshaft. New rear u-joint. $100 shipped.

I've also got some centerbolt valve covers, stock rockers/rails, stock 2001 cam, and good used water pump (SOLD) for sale if anyone is interested

 

Ttt