Need to sell all ASAP


$3200 O.B.O. feel free to make offers


1989 IROC Z, **SOLD**

on to the parts for sale


355 less then 1000 miles on fresh bore
1995 one piece rear main seal block
Dart Iron Eagle 200cc 72cc chamber, 2.02/1.60 valves
10.7:1 CR
KB hyper pistons
PM rods
Steel crank
Comp Cams XR270HR cam w/roller lifters
CC push rods
heads have new CC 986 springs/retainers/10*locks
no rocker arms (had some harland sharpes on it but the won't clear the bigger springs)
Moroso 7 qrt oil pan
Melling HV oil pump w/ moroso pick-up
$2000 O.B.O. , feel free to make offers
can deliver within 200 miles of Detroit^^

GM TPI set up, base(85 f-body w/ old type bolt angle), clean non-dented runners, upper plenum, Throttle body, fuel rails, stock injectors, you can have 19# or 22#, cable bracket, vette type metal dist. cover, no bolts..............$250 obo

A set of eight 30 lb. Tomco "green band" high impedance Rotary Disc injectors. They look to have little or no mileage on them. Silicone grease is still dabbed around the o-rings and injector tips. These were popular in the GN/Syclone world because of their high resistance to fouling or clogging, and I think they are manufactured by Lucas.............$100 obo pic


If anyone is installing a cage in a third gen, I have a dash pad perfect for cutting, all that is wrong with it is the drivers corner is broke off......free if you pick up, throwing out soon

complete set of third gen accessory brackets, with P/S pump and A/C compressor,w. water pump and crank pulleys, no alt., can send alt pulley if you want it.......$200 O.B.O.

Harland Sharpe Roller Rockers, narrow body, NSA, 1.5 ratio, low miles(less than 5000 miles)......$150 O.B.O.

all prices are before shipping

 

ttt

 

come on guys, all prices negotioable

 

ttt