Mark Williams Duralcan Metal Matrix Composite aluminum driveshaft with Mark williams th400 yoke. this is a very light and very strong driveshaft and yoke that will handle a lot of power. 3.5" diameter, for 4th gen with th400 and rearend moved backwards 1". 1350 rear u-joint. i can take actual shaft measurements if needed. has a cosmetic scratch on front yoke (nothing that will hurt it at all), perfect other than that. only selling because i switched to a powerglide and will be ordering another one of these same shafts for that setup.

was $740+ shipping new, i want $400+ shipping

dn95formula@aol.com

 

u can get this brand new from http://www.spohn.net for 325

 

that is not even close to the same shaft. go ruin somebody elses post

 

Was this for a 12-bolt rear?

 

i have a 9" rear. will work on 10 bolts, 12 bolts, or 9" with 1350 standard length yokes on them