Well once again i am selling a rear end
Strange 12 bolt:
3 Channel ABS
33 spline
1350 Yoke
Eaton HD Posi
T/A Heavy Duty Cover
LCA Relocation Brackets
Solid Pinion Spacer
Painted Gloss Black
3.90 Richmond Gears (200 miles, PERFECT pattern, checked mutliple times by a very respectable gear installer, bearings have 200 miles on them as well, everything is perfect, make little noise around 60ish mph. Richmond says its normal, i just cant stand any noise from my rear end PERIOD. Decided to go with a 3.42 stock rear instead)

Spent over 500 bucks on New gears/bearings/Install. Rear end is fully bolt in and requires no modifcations at all.
Have sold planny of parts (few rear ends too ) no problems with any transations. You are welcome to ride in the car and listen to the rear if you want. I am located near Atlanta, GA.

Asking $2000 plus shipping.

 

PM sent...

 

pm sent back

 

Why not just get a 9in. Buy a rearend housing and axles then go to a junk yard and find a posi 3.50 gear ratio out of a pick up, it will be 31 spline, since it will be set up by Ford with Ford gears it will be quiet, and throw it in and you'll be ready to rock. You can build your own ABS setup if you want to also if you have 3 channel or get a 4 channel setup.

 

willing to take a 3.42 rear end and money for the 12 bolt? it has motive 3.42's, ta rear end girdle, and new GM unit and bearings. installed professionally and makes no noise at all. no hard launches cause i havent had slicks on the car

 

Would you trade for a Yamaha warrior 350 ? I live in ga to

 

is this still available????