Mac 1+5/8" mid-length headers for 94-95 F-body. Will also fit 93 with a little AIR tube relocation (or elimination) and 96-97 if you add an s-pipe to your catback.

The headers and y-pipe are used, but the offroad pipe is brand new, as well as the studs and nuts. Includes AIR, EGR, and O2 connections in the stock locations, and a starter tube that can be cut and welded to your cat if you need to stay emissions legal. Install it with the offroad pipe and everything will bolt up with no welding required.

These were recently cleaned and painted with silver exhaust paint. They had most of the original ceramic coating intact when I got them (and still do, underneath the paint).

I did not run these myself, as my ongoing project changed directions again. I did bolt them up to see if they would fit with my BMR k-member (they don't, without modification). The previous owner bent the outside edge of one of the flanges by using the wrong gasket, but this can be easily straightened.

BTW, Macs are the only aftermarket header that uses the outside (stock) bolt holes. I was planning to drill 4 new holes so they are in the correct position for the Fel-Pro 1470 gaskets, but the stock GM gaskets would work fine.

I'm asking $350 + shipping, PayPal preferred. I'll provide a set of new ARP 3/8"x1" 12-point header bolts for an extra $10 if you need them.
PM or email me if interested.

 

+++

 

Will you sell the header bolts separately?

 

Only if whoever buys the headers doesn't want them.

Jason

 

do you have any pics.my email is jeffab87@yahoo.com and how would i beable to fix the flanges

 

Sent pics, including a close up of the one flange, which as you can see isn't that bad at all. It can be fixed with a big hammer, or torch it and bend it.