FS 355 shortblock
#1
FS 355 shortblock
This motor has a little under 10K miles on it since I built it a couple years ago. Ran fine,parting the motor and returning car to stock to be more of a gas friendly daily driver.Cross hatching still looks as good as the day I put it together.
Sealed Power high volume oilpump Part# SLP-224-4143
.30 over 4 bolt main,2 piece rear main seal.
Speed Pro forged pistons-part # TRW-L2256F30
Factory pink rods,sonic tested,magnafluxed and 3/8" ARP bolts installed.
Childs & AlbertDura-Moly rings,std Tension,Part# 200RS9902-30
Eagle cast steel crank,part # 356-103503480
Moroso 6 qt. oilpan,part # 710-20180
Cloyes dbl. roller timeing chain 220-9-3100
chrome cover.
Fluidampr Streetdampr #388-670100
Tavia timeing pointer # TAV-02350
All Clevite77 bearings thru out.
Comp Extreme Energy hydraulic cam
284*/296* Adv Dur. 507/510 lift
Casting/stamped numbers off the block:
Stamped into the front pass. side pad is V0510TBD
Cast into the rear, drivers side is 3970010.
$800 plus shipping or will trade for a good set of heads,Holley Stealth Ram setup,etc.
Will ship but prefer local buyer so it can be inspected before purchaseing.
With machine work it would cost over $1500 to duplicate.
Sealed Power high volume oilpump Part# SLP-224-4143
.30 over 4 bolt main,2 piece rear main seal.
Speed Pro forged pistons-part # TRW-L2256F30
Factory pink rods,sonic tested,magnafluxed and 3/8" ARP bolts installed.
Childs & AlbertDura-Moly rings,std Tension,Part# 200RS9902-30
Eagle cast steel crank,part # 356-103503480
Moroso 6 qt. oilpan,part # 710-20180
Cloyes dbl. roller timeing chain 220-9-3100
chrome cover.
Fluidampr Streetdampr #388-670100
Tavia timeing pointer # TAV-02350
All Clevite77 bearings thru out.
Comp Extreme Energy hydraulic cam
284*/296* Adv Dur. 507/510 lift
Casting/stamped numbers off the block:
Stamped into the front pass. side pad is V0510TBD
Cast into the rear, drivers side is 3970010.
$800 plus shipping or will trade for a good set of heads,Holley Stealth Ram setup,etc.
Will ship but prefer local buyer so it can be inspected before purchaseing.
With machine work it would cost over $1500 to duplicate.
#3
Re: FS 355 shortblock
Your looking at around $100 for shipping.
I don't have any pics of it now it's tore down to a shortblock but I do when it was a full longblock setting in the car.
I don't have any pics of it now it's tore down to a shortblock but I do when it was a full longblock setting in the car.
Thread
Thread Starter
Forum
Replies
Last Post
SpraydZ
Parts For Sale
42
06-07-2016 01:44 PM