I got shafted on a set of rocker arms (pardon the pun). I was told these were a barely used set of CC 1305-16s (1.6 pro-magnum rockers for 7/16" studs). When they arrived, it turns out they were not even close to the same thing... And to top it off, parts were missing. The !@#!@ seller wouldn't make it up to me either.

Anyway, these are Comp Cams 1418-16 1.6:1 ratio self-aligning Magnum roller-tip rockers. They all appear to be in good condition. I checked each roller individually. One rocker arm was obviously replaced, but with the same type of rocker. This will not affect their function in any way.

Now, for the missing parts. On top of getting screwed, I felt I couldn't honestly sell these to anyone else without replacing the missing parts. I spent another $40 on brand new ***** and nuts from comp cams to go with them.

These retail for $180 new. I have more than that in them because of that seller. I would like to get $120 shipped for them, but will entertain all REASONABLE offers.

Pics below. The lower right rocker is the replacement one. The 2 bags contain the brand new ***** (1400B) and nuts (1400N).
low res: http://www.lt1.org/other/jpg/1418-16low.jpg
high res: http://www.lt1.org/other/jpg/1418-16high.jpg

 

ttt

 

new price -- $120 ??

ttt

 

Well, I might take them.

Depends on if this other deal goes through or not.
Where are you located??

 

I'm in O'Fallon, IL.

I know I don't have a lot of posts here, but just for reference, i'm a senior member and moderator on FAST (F-Body Association of St. Louis -- http://www.fastlouis.com )

 

ttt

 

sent you a PM

 

Will they fit a stock LT1 if i get new springs?

-Dustin-

 

With any stock LT1 cam (93, 94-95, or 96-97), the max lift of any of the cams will be at .491" with 1.6 ratio. The stock springs should easily take that... But it definitely wouldn't hurt to throw a set of LT4 springs in there.

I have a sale pending now, but will reply here if they are still available.