Guys selling my Canton Valvecovers off my procharged LTX motor. These have only about 40 minutes run time on them so they are Brand new basically. I Paid $215 shipped to the door and I would like $175 shipped to your door (Figure it will cost me $25.00 to ship these considering frieght prices lately)
I had the spot welded up on the passenger rear valvecover so no need of a cheap grommet.
Selling b/c I have speedinc's alternator relocation and I think the engine will look better with different valvecovers, may even go perimeter bolt.
Here are some pics of them

 

How about a bio on your build. That is one bad*ss motor. like the radiator setup.
bump for the day

 

still have these? how much taller are they than stock?

 

are they coated or can they be polished?

 

Thanks, lol. 383 with large AFR's, Maxed out D1SC procharger/FMIC/100% alky, 4L80E/paddleshift, Fabbed 9inch. Thats basically the just of the main stuff I think

Just put them up for sale last night, little taller than stock (by how much I don't know). But they are a direct bolt-in replacement.
I think they can be polished, my buddy has a setup that he polished and they look awesome.

 

do you think they will fit under a hotchkins tower brace? I think I will buy them

 

how are you venting the engine?

 

I am venting my engine from the intake valley with my blower (like a vaccumm pump)
I forgot to add I had two studs tig welded to the passenger valvecover to hold the lokar tranny dipstick. You can see it in the last two pics.

 

Where in Arkansas are you located? I'm in Littlerock right now...

Thanks,

Jerry

 

Are these sold? And where are you in Arkansas?

 

I live in Northeast part of the state, Paragould near Jonesboro.
These are not sold, but I decided to keep them. Welded some 3/8 bungs on the vavlecovers yesterday to vent my blower setup, so I will just hold on to them.

 

Ok, well if you decide to get rid of them I'll take them. The venting would be perfect for my turbo setup.

Jerry