AFR 227 LT4 heads, Victor E single plane intake, PTE 100*Elbow, Accufab 90mm T-body
Thread Starter
Registered User
Joined: Feb 2000
Posts: 787
From: AUSTIN (Georgetown), TX
AFR 227 LT4 heads, Victor E single plane intake, PTE 100*Elbow, Accufab 90mm T-body
Going to upgrade and need to sell. Parts are still on the car, will pull off when sold. This setup put down 535 rwhp N/A and 814 rwhp on nitrous with a 396.
AFR 227 LT4 HEADS:
Heads were hand ported by Harold Hallam about 4 years ago and he said they flowed 318 cfm @ 650 lift. They are 56cc and uses LT1/4 intake bolt pattern. Springs are setup for solid roller .700 lift. Can't remember the spring pressures. Maybe 240 closed and 650 open.
Edlebrock Victor Efi intake:
Converted to LT1 bolt pattern and uses angled spacer washers with the bolts. Fully ported to match heads. Very nice Intake. Powder coated red. Includes fuel rail kit. Already drilled and tapped for direct port fogger. The nozzles, plumbing, manifolds included. Water neck was machined off.
PTE 100* elbow:
This Elbow was machined down for hood clearance and fully ported. Powder coated red.
Accufab 90mm polished throttle body:
This throttle body has the upgraded GM IAC block with GM IAC attached. Ford TPS Sensor also attached.
Would like to sell this as a complete package first before I break it up. It fits and works well together so of course I want it to sell together. If not...I will split it up.
$3,500.00
Please PM me if you have any questions.
Tony Shepherd
AFR 227 LT4 HEADS:
Heads were hand ported by Harold Hallam about 4 years ago and he said they flowed 318 cfm @ 650 lift. They are 56cc and uses LT1/4 intake bolt pattern. Springs are setup for solid roller .700 lift. Can't remember the spring pressures. Maybe 240 closed and 650 open.
Edlebrock Victor Efi intake:
Converted to LT1 bolt pattern and uses angled spacer washers with the bolts. Fully ported to match heads. Very nice Intake. Powder coated red. Includes fuel rail kit. Already drilled and tapped for direct port fogger. The nozzles, plumbing, manifolds included. Water neck was machined off.
PTE 100* elbow:
This Elbow was machined down for hood clearance and fully ported. Powder coated red.
Accufab 90mm polished throttle body:
This throttle body has the upgraded GM IAC block with GM IAC attached. Ford TPS Sensor also attached.
Would like to sell this as a complete package first before I break it up. It fits and works well together so of course I want it to sell together. If not...I will split it up.
$3,500.00
Please PM me if you have any questions.
Tony Shepherd
.
Thread
Thread Starter
Forum
Replies
Last Post
