When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm offering a stellar deal on these heads due to a slight issue that needs to be addressed. AFR 210 LT4 heads ported by Lloyd Elliot. The heads are brand new with about 1-2 minutes of run time. They were purchased bare and sent to Lloyd for porting, machining, and assembly.
There is a very small hole in the spot face area of the forward most head bolt hole on the passengers side head (shown in picture below). I have no idea how this happened as the previous owner purchased them from another forum member who purchased them new. This could have been a defect from AFR. Either way, this area will need to be sealed up (threaded plug or weld). This is a relatively easy and inexpensive repair for any capable cylinder head shop. These heads were over $2600 new. They flow very well and have the capability to make some major power.
I bought an unfinished “project” car a couple years ago from an acquaintance. It was a high dollar build that he couldn’t finish (financially). He got the car running (literally 2 minutes) for the initial start up. He didn’t have a radiator in the car hence the reason for only running it a short time and not getting it up to operating temp.
I wanted a few parts off the car and sold off the rest. These heads were one of the items I wanted. He bought the heads unused from the original owner (cz28 forum member) who I also have known for years. The original owner bought them from AFR and had Lloyd port them about 10 years ago.
When I pulled the motor out of the car, I noticed a little bit of coolant in the oil. I started doing diagnostics and found this small hole under one of the headbolt washers. A little bit of coolant was making its way past the bolt. It just needs to be plugged or welded up. Very odd defect, and I’m almost certain that it came for AFR that way I detected by quality control.
Was the portwork done for a boosted application or NA? I have my turbo LT4 apart that has fully ported and assembled AFR 195's but might consider these since I've already get her apart.
I'm waiting on my tax return so as soon as the money gets here ( about 2-3 weeks) I'll take them Jason, I brought the shortblock that these heads were on.
I'm waiting on my tax return so as soon as the money gets here ( about 2-3 weeks) I'll take them Jason, I brought the shortblock that these heads were on.
