accel gen7 DFI for LS1
Thread Starter
Registered User
Joined: Feb 2004
Posts: 948
From: Stroudsburg, PA
accel gen7 DFI for LS1
I've decided to sell my accel DFI gen7. it is practically brand new, only used to start an engine and has zero miles.
it is a complete engine wiring harness with ECU. it will plug right into place of the factory wiring harness.
some stuff it has to offer:
real time changing of engine parameters
nitrous control system
real time graphical data displays
3D graphical calibration environment
high/low impedance injector compatible
integrated data logging and analysis system
fuel map auto generation utility
fuel injector pulse width and duty cycle predicting utility
onboard diagnostics system with automatic fault compensation
hardened electronic circuitry with built in hardware protection
this also has shift light, knock sensor, 2 step, 1, 2, or 3 stage nitrous control, and comes with a wideband and controller ($1200 option)
this is over $2800 new. Im looking for $1500 obo.
pictures:
http://rides.webshots.com/album/555667961iEPdNx
it is a complete engine wiring harness with ECU. it will plug right into place of the factory wiring harness.
some stuff it has to offer:
real time changing of engine parameters
nitrous control system
real time graphical data displays
3D graphical calibration environment
high/low impedance injector compatible
integrated data logging and analysis system
fuel map auto generation utility
fuel injector pulse width and duty cycle predicting utility
onboard diagnostics system with automatic fault compensation
hardened electronic circuitry with built in hardware protection
this also has shift light, knock sensor, 2 step, 1, 2, or 3 stage nitrous control, and comes with a wideband and controller ($1200 option)
this is over $2800 new. Im looking for $1500 obo.
pictures:
http://rides.webshots.com/album/555667961iEPdNx
Last edited by Zigroid; Feb 28, 2007 at 09:03 AM.
Thread
Thread Starter
Forum
Replies
Last Post