I want to make a few changes to my car for next season so here are a few things I have for sale.

1) SLP Ultra Z hood for 93-97 Camaro. The hood is painted red and it has been clearanced on the bottom. Top of the hood and finish are perfect. Asking $365.00 sold

2)Callies Pro 1 Billet rods used. 5.7 length good for big HP need to be resized Asking $ 380.00

3) Callies Stealth crank 1 piece rear main seal. 3.750 with 350 mains works for both 5.7 and 6.0 inch rods, Knife edged with 5 slugs of mallory (internal balance). Needs to be cut .10 under..maybe .20. I am not sure so the price is right Asking $225.00 sold

4) TH400 Transmission built by API transmission. Full manual reverse with transbrake. 275lbs of presure. This is a very serious unit. I went 160 mph with it. Asking $1200 fresh ready to go.

5) API one piece torque converter. This is a 9 inch nitrious converter. Very, very tight. Stalled 4000rpm off the brake in my car. Probably lower in yours. All the toys, Forged aluminum stator, Anti balloon plates, etc... I also used this converter to go 160 mph. Converter is in perfect shape ready to use. This is a non lockup converter for Th400 or Th350 tranny. Asking $ 550.00


All prices are shipping extra. All items are ready to be shipped. If you want more info please contact me at vincemc@ils.net


Vince

 

Hey, I am open to offers.

Vince

 

dont want to sound stupid but....

clearenced on the bottom? what exactely does that mean

 

The back of the hood where it meets the cowl has a double floor. That's the way it is constructed so you can have an air box in the front of the motor. Anyway. I was running a carb set up and I had to trim part of that bottom floor/ section in order to fit over my carb. The section is about 2 inches by 2inches in a square. There is no structural support there so the hood has been sounds structurally. I am sure you could reglass it if you wanted too. The hood is fibre glass.

Vince

 

Vince, I'll take the Callies crank from you. Do you want me to send the money with the other $50 I am sending?

Email me, thanks man
Jason

 

Sure put all together and send it up to me. I can send the crank to buffalo next week. Friday actually.

76 amberview drive
Keswick, Ontario
Canada
L4P 3Y3

thanks Vince

 

I still have the connecting rods and the tranny and converter. All serious offers will be considered.

Thanks

Vince

 

I know my tranny is going. I have a 95 Z28 M-6. Would the TH400 be a good replacment?

 

The Turbo400 is a three speed nonoverdrive nonlockup tranny. The one I have for sale is built for drag racing use. It will work on the street for short hops and putting around town as well but for the highway its a waste of time and money. If you want to drag race this is a great tranny and converter for you. Let me know and good luck.

Vince