Engine, built by Harshaw Racing Engines
Forged Rotating Assembly (Eagle Crank & H-Beam Rods, JE Pistons) Lloyd Elliot Ported Stock LT1 Head Castings w/Manley Valves (2.00 Intake & 1.56 Exhaust) (LE2)
Joe Overton Custom Ground Cam
PAC 1518 Beehive Springs
Comp 1.6 NSA Roller Rockers
Ported LT1 Intake
BBK 58mm throttle body
OBDi pcm conversion
Meziere Electric Water Pump
Moroso Oil Pan and High Volume pump
Cloyes Double roller timing chain
ARP Head studs

Looking for 5000 cdn obo.

Motor has under 10,000 km's, all n/a

 

wish this was up for sale 3-4 months ago....could have sent it to the east coast. heres a bump for ya...good price....

 

no...first time putting the motor up.....thanks for the good words, i could always still sent it out

 

whats the compression ratio of this baby?

 

10:1

i also forgot to add that the block is splayed with 4 bolt mains from program, and its oring'd around each piston. sfi damper on the crank too.

 

ttt...anyone intersted?

 

ttt....open to offers and would also consider splitting the motor and selling as a short block and a top end. want to get moving on a winter project.

steve

 

any dyno or track numbers for this motor? what would you want for just the shortblock?

 

387/409...12.0@112 on 91.

2800...for the shortblock

 

those numbers are kinda low, not knockn on the numbers though. was it a smaller cam?

 

it was tuned by myself....the cam isn't a monster either

 

ttt...anyone?

 

ttt...open to offers....looking to go a different route. i have a complete parts list of the motor, if anyone is interested.