*NEW* 96-97 LT1 Pacesetter long tube headers--coated w/emissions $365
03-14-2007, 10:00 AM
#1
Registered User
Thread Starter
Join Date: Dec 1999
Posts: 1,119
*NEW* 96-97 LT1 Pacesetter long tube headers--coated w/emissions $365
$365 shipped
New and never installed.
There is a slight indentation on the first pipe from the front on the drivers side header by the air tube. The air tube was pushed a little during shipping and made a small indentation on the inside of the tube right where it curves to meet the flange, but it will not affect fitment or installation.
It is hardly noticeable and unless you are familiar with these headers, you would think it came from the factory that way.
This was an extra set that I had and mistakenly sent to the wrong person so they shipped them back to me which is when the air tube was tweaked. I already have a set installed, otherwise I'd use them.
If you are interested and want pics, send me your email.
New and never installed.
There is a slight indentation on the first pipe from the front on the drivers side header by the air tube. The air tube was pushed a little during shipping and made a small indentation on the inside of the tube right where it curves to meet the flange, but it will not affect fitment or installation.
It is hardly noticeable and unless you are familiar with these headers, you would think it came from the factory that way.
This was an extra set that I had and mistakenly sent to the wrong person so they shipped them back to me which is when the air tube was tweaked. I already have a set installed, otherwise I'd use them.
If you are interested and want pics, send me your email.
03-14-2007, 10:46 AM
#2
Registered User
Join Date: Jul 2005
Location: Minnesota
Posts: 160
im interested... get back to me with some more pics (especially of that bent part if you have them)
njenson24@hotmail.com
njenson24@hotmail.com
03-15-2007, 02:14 AM
#3
Registered User
Thread Starter
Join Date: Dec 1999
Posts: 1,119
im interested... get back to me with some more pics (especially of that bent part if you have them)
njenson24@hotmail.com
njenson24@hotmail.com
let me know if they are good enough
03-16-2007, 09:25 PM
#8
Registered User
Thread Starter
Join Date: Dec 1999
Posts: 1,119
Thread
Thread Starter
Forum
Replies
Last Post
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM