Will this survive a 200 shot?
#1
Will this survive a 200 shot?
I've got a fully forged bottom end. eagle/srp combo
The ring gaps were set at .020 and .022 I believe, however it might have been 18 and 20 i cant find the sheet I wrote it down on!
The car also has 2 stud mains with ARP hardware.
I was planning on spraying an occasional 200 shot on this, most of the time probably staying at 150.
My main concern is the ring gap. But then I see some folks with stock bottomends running 175.... so any insight is needed!
The ring gaps were set at .020 and .022 I believe, however it might have been 18 and 20 i cant find the sheet I wrote it down on!
The car also has 2 stud mains with ARP hardware.
I was planning on spraying an occasional 200 shot on this, most of the time probably staying at 150.
My main concern is the ring gap. But then I see some folks with stock bottomends running 175.... so any insight is needed!
#5
ya i was planning a dual stage for the stret. I'll probably only run 200 shot occasionally at the track.
But at the track I was planning on running both stages at the saem time off the line, is that too much for the setup
But at the track I was planning on running both stages at the saem time off the line, is that too much for the setup
Thread
Thread Starter
Forum
Replies
Last Post
68camaroboltz
General 1967-2002 F-Body Tech
3
10-05-2015 11:56 PM
PFYC
Supporting Vendor Group Purchases and Sales
0
09-18-2015 03:46 PM
NewsBot
2010 - 2015 Camaro News, Sightings, Pictures, and Multimedia
1
09-15-2015 11:53 AM