Just ordered nitrous what should I expect?
Just ordered nitrous what should I expect?
All of my current mods are in the signature. I just ordered a NX Wet kit, and I plan on running a 100 shot. I haven't been to the track yet, so I don't know what times to expect. What do you guys think I will run, with and without nitrous? Thanks for your opinions.
Its all going to depend on the 60' time. Those C5 wheels aren't exactly a drag wheel, plus with an M6 car you may have issues leaving the line. Not that it can't be done, but there is a certain finesse to leaving the line that you must learn. Seeing as this car has never been to th track I figure you will lay down a few high 13's before you get comfortable with it.
I have seen cars with less mods than you have touch 13.0's on motor, and with a 100 hit lean into the 12.50 area. As long as your car leaves ok (sub 2.0 60') then you should be a low-mid 13 car on motor and a mid-high 12 car on spray.
Plus you already have the best nitrous kit that money can by. The service and build quality of the NX stuff is second to none. Now get that bitch installed and have some fun.
I have seen cars with less mods than you have touch 13.0's on motor, and with a 100 hit lean into the 12.50 area. As long as your car leaves ok (sub 2.0 60') then you should be a low-mid 13 car on motor and a mid-high 12 car on spray.
Plus you already have the best nitrous kit that money can by. The service and build quality of the NX stuff is second to none. Now get that bitch installed and have some fun.
I agree with Nick. 1st time at track ,no DRs,and M6...you should be happy with a mid to low 13 NA and about a second better on juice.
Make your 1st pass at about 80% NA to get a feel for everything.....then make a couple of all out NA runs. Let everything cool down good before making a run on juice.
Make your 1st pass at about 80% NA to get a feel for everything.....then make a couple of all out NA runs. Let everything cool down good before making a run on juice.
Thread
Thread Starter
Forum
Replies
Last Post
PFYC
Supporting Vendor Group Purchases and Sales
0
Jul 17, 2015 02:47 PM



