Does anyone make an 1/8" npt distribution block, that has a male on one end to screw into the bottle, and 2 females on the other end? I want to screw my gauge and my bottle warmer switch both into the bottle, but only have one spot to do so.

 

Black
http://www.nitrousoutlet.com/catalog...roduct_id=2697

Blue
http://www.nitrousoutlet.com/catalog...product_id=368

 

Isn't the fittin on the bottle an 1/8" NPT fitting? I am wanting to put something in the female fitting on the bottle where the gauge mounts, that way I can have 2 things there instead of just one, and so I can see bottle pressure and use the automatic warmer switch all the time instead of just when the bottle is open.

 

misread the OP.....
to fab it the way you are describing you will need:
1/8nptX1/8npt union
http://www.nitrousoutlet.com/catalog...product_id=956
Distribution block
this one is a 1 in 3 out...cheapest one we have
http://www.nitrousoutlet.com/catalog...roduct_id=1143
and a 1/8 npt plug for the unused hole
http://www.nitrousoutlet.com/catalog...roduct_id=2712

or you could replace the whole valve...my reccomendation
http://www.nitrousoutlet.com/catalog...roduct_id=2148

our valve comes with 2 ports built into the valve body

 

I think I might just do that. If I ordered it before noon, when is the earliest it could get here by?

 

ship today you will have it tommorrow using UPS ground


if you are going to order online make sure that your current bottle uses the 2 piece bottle nut/nipple if your uses the 1 piece (660 style) you will need a 326 style bottle nut and nipple