Need Help????
#1
Need Help????
hey guys im getting ready to throw my forged 355 short block in its all ready balanced and ready for the cam....my questions are how do you find top dead center for an lt1?.....Should i get a degree tool or is it not needed? I know i need a complete gasket kit but is there anything else you guys can think of, keep in mind this is the first engine swap i have ever done any help would be appreciated.........thanks alot for your replys.....Jerry
#5
Wolfie has ya covered on the zoomie eye ball method
It would go like this link:
http://www.2quicknovas.com/happyTDC.html
I have ya covered with the real deal
http://www.fourwheeler.com/howto/67578/
It don't matter lt1, v-12,I-4, v-6, turbo buick, ack:ford: ack, buick, olds, rolls can hardly....
...follow the link Bro, Follow the link
It would go like this link:
http://www.2quicknovas.com/happyTDC.html
I have ya covered with the real deal
http://www.fourwheeler.com/howto/67578/
It don't matter lt1, v-12,I-4, v-6, turbo buick, ack:ford: ack, buick, olds, rolls can hardly....
...follow the link Bro, Follow the link
Last edited by Hot Rod Hawk; 11-21-2003 at 03:26 PM.