I had midas make me a custom y-pipe for my LT headers,
The crap they built was awful at best, Hurge creases where they bent it gives me 0 ground clearnce and it hits my floor board right at the trany tail shaft.

Well what would be the best way to take care of this. I dont realy have the loot to get another y-pipe built, For now i have put a small meatel shim there so it doesnt rattle it just sounds wierd inside the car now like i have a 15" sub hooked up to my exhaust.

i am thinking about heating it up and bending it just a tad but will a lil propane tourch heat it up enuf?