A few months ago I wen under my car to tghten up the y-pipe to headers 9/16 (i think they were anyway) bolts. The damn things were rusted through and snapped at the middle - two out of the four holding the pipes together. I have the SLP shorties installed, and the bolts have no nuts at the end, they are tightened into a back panel with a thread cutout. Anyway, I drilled thouh the little bolt piece that was stuck and ran knew slimmer bolts through the holes I drilled and put nuts on the ends to hold the pipes. These bolts that I found in some hardware store are flimsy and had bend almost immediately. My question is do any of you know where I can get TITNIUM bolts - a size thinner then stock so I can slide them through the holes I drilled.

Sorry about the book I wrote but I hope I made sense.

 

Check out ARP they offer some damn good bolts, you pay for the quality, but it's DEFINITLY worth it!


Tim

 

Thx Tim, but do you have the URL? I tried a google search and got nothing.

 

Summit Racing carries a full line of ARP bolts as well as Jegs and various other vendors.
Give Summit a call or visit their website
http://www.summitracing.com

Nick

 

http://www.arp-bolts.com/