Alright, about a month ago, I was putting my new opti, new waterpump, new wires, and plugs on. Well when I got everything back on, the car would only start when the MAF was unplugged. Well yesterday, I recieved my new MAF, and put it on today. Well my car started with it plugged in, but would die after about 5 sec. It did this for about 10-15 times. Then it would run alittle longer and the rpms started to jump from 1000 to 600 and about a min or two it would die again. I unplugged the MAF and it runs fine, so what is going on?????

 

anyone have any ideas?

 

Your IAT sensor is plugged in? Elbow is on?

 

everything else is plugged in and put on.

 

Anyone????

 

ttt

 

No code yet?

 

it snowed to much up here in the last day, so when it goes away, i will take it up to autozone to scan for codes. I will have to drive it up there with the MAF unplugged.