what wires and setups for wires you guys running becaus emy msds suck horribly....I will never buy again they are arching through the insulation without even being burned

 

that's very rare, it has to be cut because they just don't do that. Taylor makes a good wire that has a smaller boot which works well with the Jethots. I'd see if they'd warranty a new set in your situation. 9 times out 10 it's a wire that got too close to a primary and is cooked which starts the arching.

good luck

 

I'm using OVC with Taylor wires.

 

I considered doing that setup with the heat sleeves, etc. But knowing the stroker will get a solid roller cam I would be perodically setting valve lash and didn't want to have all that in the way. How much work is it really though, to move them that is?

thanks

 

I personally see it as a pain in the *** Seriously though all you have to do is take the bolts out and move the looms and wires to the side.

 

Yeah I was thinking about the otvc kit alsoa nywhere cheaper than 99.99 for everything?

 

I run MSD superconductors in the stock locations basically, I have 2500 on the LT install and not 1 burnt wire.
I really like the MSDs they are the best wire I have found to date.

 

I too, run a Taylor OTVC combination with Made-For-You looms, and wouldn't really use anything else.