What is needed for OBD1 swap
Registered User
Joined: Aug 2000
Posts: 504
From: Portland, OR
see info at www.pcmforless.com
Registered User
Joined: Nov 2002
Posts: 588
From: Indiana
If you don't want to change knock sensors, you can solder a resistor (3.9kohm) from one of the terminals to ground. I can't remember which terminal. If you do it this way, you can swap PCM's back and forth without any coolant loss.
Thread Starter
Registered User
Joined: Mar 2002
Posts: 1,834
From: Lower Mainland, BC ,Canada
Originally posted by remaxracer45
whats the benefit to this swap?
whats the benefit to this swap?
easier/cheaper to tune
u dont need o2 sims if u wanna gut the cats
Makes things easier w/ tuning and stuff
Thread
Thread Starter
Forum
Replies
Last Post