what kind of 1/4 mle time would a 95 A4 z28 get stock except these mods

FLP longtubes kit
magnaflow exhaust catback
slp CAI
and a few type R stickers (jk bout that one)

also, are those mods too much for the stock A4 and rear end?

 

Your rear should be fine.

As for your 1/4 ET - I'm assuming you have a 3.23 gearset? If so, and you had some practice runs, I would say 13.8. Maybe 13.6 on a cool night.

Greg

 

thanks for the reply. what do you think about the A4. will it be able to handle that power, or not? how much rwhp would the setup get, and how much can the A4 handle?

 

ttt

 

you'll be fine your not pushing *That* much more horsepower then stock depends on how the a4s holding up, lots of a4s have problems even if there stock to the filter.

 

how much horsepower do u think will be made?

 

260-280ish rwhp! and a 14.6-8 sounds about right

 

im hoping you mean 13.6-8

 

Should easily run mid 13's. If it doesn't something is wrong.

 

When I had a K&N intake, electric water pump, slp headers and flowmaster catback on drag radials I ran 13.5 @103.7. Yours should be somewhere close to that.

 

thanks for the responses. this may be a dumb question, but are longtube headers street legal or what?

 

Technically no because you have to change the placement of the catalytic converter(s). However, if you live in an area where there is no emmissions inspections you'll be fine. Also if all the test consists of is a "tailpipe test" and they don't look under the car you'll be ok.

John

 

that is what I meant