All I have is the pump itself. I bought it used (255lph) and hopefully it will be good.

But anyways, what all will I need as far as clamps, wires, anything to make this little thing replace the factory pump. I found one pic that looks like the Walbro has a short wire harness extension, maybe? New tank hasket (if applicable) sock?

Thanks!
Graham

 

you can make the wire xtension yourself.. then you will need a small pice of 3/8 fuel line I think thats the right size and 2 small clamps for the fuel line and 2 clamps to hold the pump on if you need pics of all this I have a pump new in the box I am shipping it out tomorrow so let me know soon..

 

Alright, thanks! Basiacly just some spare 3/8" fuel line, clamps for it and clamps for the pump body. What about a sock or pre-filter?

Any advise for splicing in the extension (so I dont blow myself up)?

 

I bought a walbro from someone off the board and he sent me a kit along with it. When I installed the pump all I used was the wiring adapter/harness that pluged into the walbro and then into the factory wiring. It was a simple plug and go. Other than the harness I didn't use anything else from the kit. I did reuse the factory plastic fuel bucket and I pried off the flex hose off the old factory pump and then glued and clamped it to the new walbro to make sure it wouldn't come off.

 

I just started installing my 255lph in-tank pump and I bought it new and it still didn't come with the pig tail plug and the filter sock, how can I make my own wire extension? I called the place I got it from & they told me to cut the stock plug and put 2 female connectors on there and fill it with non-conductive silicone or epoxy? This don't sound good to me how have you seen this done without the plug?

Thank you!