My car idle/rev threw an open cut out.


Uploading right now.


Will post link in about 6 minutes.

 

Dial up beware.... file is 20MB

 

that is freaking sick! make sure you dont run over that baseball! lol

 

deatils on he setup!


and get some gas in that car b4 u burn the pump up!

 

What size is that cam? if you can say.. it kinda sounds like my cc306...

 

Yeah... it's just been sitting for a while, I think I am going to bring a 5gal container home to put in it. Sitting 'cause it needs a trans.... I guess I have to dish it out on this one and get a centry trans, the car has already been through 5 really good built trannys.

 

It's just a little bigger than that.



My setup:


GM847 (234/242) on a 112LSA
1.52 Comp ProMag rr's making the lift #'s .546/566
P&P Heads (don't have the flow sheet with me)
PaceSetter LT's & Off-Road Y-pipe
3" Flowmaster Cat-Back w/cut-out before the axel.
52MM TB

 

Been a long time man. I hope to have mine up and running before the week is out. I also think its time to swap to a T-56.

 

Sounds really good!

 

Sounds sweet! I remember my 94 with the 847 cam and Flomaster exhaust.

Rich

 

It has been a while... I think I might have to make a trip up there whenever I get a new trans.

 

o my

 

Oh yeah, and 36LB injectors/Walbro intank HPHV255 (talked to someone there and the told me it was actually a 355lph unit) and a NX Wet Kit.

 

i can't wait to install mine now

 

Nice!!