Just got a call from the guy doing the work on my car. I got the opti conversion kit from Nu-Tek. The problem is that the new wiring harness for the opti is not mating up with the wiring harness on the car. Has anyone else run into this, or is it a matter of cutting a clip on the new or factory harness or what?

 

On our 93's, you have to dig a slot (indentation) on harness connector. They do not match, but it will work fine. I used a hot soldering iron to melt a indentation so the little slot could slip in.

Should work fine. Look closely and you will know what I mean.

 

Big time thanks! I owe ya broh!