Users of PAC1218/1518 springs... what hardware are you using?
Thread Starter
Registered User
Joined: Aug 2003
Posts: 2,925
From: Detroit
Users of PAC1218/1518 springs... what hardware are you using?
locks, retainers, rockers, all that jazz.
I want a good valvetrain... wondering if there is better stuff out there than comp (within the same price range). Installing a 503 this spring if that matters.
thanks
I want a good valvetrain... wondering if there is better stuff out there than comp (within the same price range). Installing a 503 this spring if that matters.
thanks
Registered User
Joined: Apr 2003
Posts: 316
From: Idaho Falls, Idaho
I am using all the comp hardware that you would with 918s, seats, 10 degree retainers, and +.050 locks with the PAC 1518s.. no problems came in at 1.75 installed height with .600 lift. Didn't see the need for other hardware when the problems were with the 918 springs themselves..
PAC can set you up I am sure.
PAC can set you up I am sure.
Last edited by J's 82; Dec 2, 2007 at 10:02 PM.
Thread Starter
Registered User
Joined: Aug 2003
Posts: 2,925
From: Detroit
I am using all the comp hardware that you would with 918s, seats, 10 degree retainers, and +.050 locks with the PAC 1518s.. no problems came in at 1.75 installed height with .600 lift. Didn't see the need for other hardware when the problems were with the 918 springs themselves..
PAC can set you up I am sure.
PAC can set you up I am sure.
Thread
Thread Starter
Forum
Replies
Last Post
browenb
General 1967-2002 F-Body Tech
5
Jul 19, 2015 04:14 PM