Hi, I just wanted to ask you, if there is any plan or DIY to build a subframe connectors like these ones http://www.slponline.com/img/part_img/70801.jpg
There is no problem with buying it, but there is problem with shipping it over the sea, which would cost something round 300 dolars and that is too much.

 

there are numerous fbody clubs in europe, perhaps you can buy them from there?

 

I haven´t seen anyone sell it in Europe.

 

how much to ship

 

approximately 300$

 

Not easy to make hte SLP ones, one like BMR would be much easier.

A buddy of mine wanted to copy mine, but after looking he said hes not even going to try, its jsut too hard to make it the same.

If you want, and can give me a few days I can take pics for you with a tape measure for you, might be able to get close enough at least.

 

OK, that´s great. Thank you very much. I am looking forward to seeing the pictures and measures. Once again Thanks.

 

It would be much easier to make some like these:
http://www.bmrfabrication.com/sfc/tubular2.jpg
http://www.bmrfabrication.com/sfc/tubular-inst.jpg

 

I agree to that.