what size checker would i need?
would 6 to 7.5 be good?

 

hmm... I guess i cant help you unless i know what your combo is
we aint all mind readers you know LOL.

 

umm well how about if i dont know what the combo is gonna be
i dont know what cam im getting or anything lol
im sure there is a certain length range that is good for a 350 lt1

since your the one that was wondering too why dont u do a search lol

 

That should work. I believe the stock length is 7.200.

 

just wait a sec i'm a mind reader.......

i'm reading that you should junk your lt1 wade and get a mustang hehe jk

no man post what heads your getting and find out what you want for a cam. you already told you me know what ya want for a cam that goes best with your setup your getting

 

well stfu mustang boy and why you on this board anyway lol. thats all i wanted to know really was the stock length. its not gonna be too much different from the stock length. give or take a bit i would imagine.

 

so did you want to go half with adam on order 6 to 7.5 ?
they sell them in pairs so you guys each get one hehe

let me know so he can order them tonight they take 4 days to get here. and plus that way i can get yours and his car out of my parking spot under ground. it's getting to be a PITA when i work on mine. i have to keep moving my beater around.

 

a guy i was talking to recommended this one:
CCA-7702-1 6.800 in. to 7.800 in. adjustment range, pushrod length checker ... $23.99

 

no good to me wade , i need 6.6 to 6.8 which the paw one will support. and it will take care of you too. awful expensive though...

 

yea i know duster im just wondering if i would possibly need that extra .3 from 7.5 to 7.8 cause if i knew i didn't then that checker you were looking at would be fine.

if stock is 7.2 them im running it close with a checker that only goes to 7.5. thats my only concern.

 

wade why don't you get ahold of that guy and ask him if 6 to 7.5 will work. then your know i guess