Well funds are tight as of now and I HAVE to get new wires after just buying some MSD's. Well anyway I dont wanna have to deal with the burning anymore so can you guys point me in the direction of some good wires to do the over the valve cover with. I guess I'll need longer than normal wires and the made for you looms. So help me out and it can only be at summit (summit card )

 

Got my Taylor's at Summit with over the valve cover looms. Worked very nice! You won't have problems. I assume of course you have headers.

Ben

 

what is wrong with the MSD's? They are what i have and i wouldn't waste money on taylors.

 

I'm have MSD OTVC setup. I'm planning to go side mounting and I plan to ditch the MSDs in favor of Taylor. I have enjoyed the MSDs but have a few complaints.

1. I had to drilled out the MFY looms to fit the 8.5mm wires. They only fit 7-8mm.
2. The MSD plug boots are rather beefy (I like it) but my FLPs primary are 1 3/4" and I have burnt alot of wires/boots because it's too close. Taylor fire sleeves has solved that problem, but it's an eye sore.
3. Taylor has smaller boot plugs.

 

ok i know what looms to get but what wires should i get...i'm gonna get the taylors but is there one particular set i should get?

 

For all of your Taylor wire needs.
http://www.thunderracing.com/index.c...ategoryid=1087