97WRAITH

Bought a Lakwood DS loop that is made for F-bodies from summit. Nice piece. Problem is my Mufflex Y- pipe interfers with it so it will not bolt up. What kind of DS loop are you guys using with the Mufflex Y-pipe?

Thanks!

Smoke T/A

I used the BMR DS loop and it cleared just fine with a few shims.
http://www.bmrfabrication.com/F-body...driveshaftloop

97CamaroZ28R

I just installed a SLP Driveshaft Loop, it cleared my Mufflex Y-pipe with no shims.

97WRAITH

Thanks I will have to check them out!

Z28_LT4

I have the BMR and I tried shimming and in my experience "on my car" their is no way it will fit. I plan to modify it ,but have not got around to doing it. If I had it to do it over again I would buy the torque arm that bolts to the g-load brace and has the loop installed further back. I think it's made by spohn or bmr

hope this helps