Will composite LT4 valve covers fit an F-Body with roller rockers without modifications? I am unsure if they will clear the alternator.

 

you will need a little mod to do it here is someones link
http://www.fbody.com/members/csabatk...lvecovers.html
hope this will help

 

I have the Pro-form Roller rockers and I had to DO NOTHING to the covers.
Go to my site in the rebuild section and take a look at the rockers. They are not self aligning so I needed guide plates. The only mod I had to do was to the alternator. I just had to not use one of the brackets. No big deal at all.

 

Well depends on the rocker. I had some with the crane gold 1.6 SA rockers no mods to the Lt4 covers were needed. I think you only have to cut them if you go to a NSA rocker and use guide plates. Yes they will clear the alternator just fine. HTH

Joe

 

I have CC 1.6 rr's NSA w/ guideplates and the LT4 valve covers fit with no modifications necessary.
HTH
Kenny

 

Two years ago I had the GM Perf. Parts 1.6 self alignings (crane golds) and they required no mods to even the stock covers. But I have the Comp Pro Mags now and they are a lot wider, which required clearancing to the cross bracing on the stockers...and I knew that was necessary with the composite covers as well.

 

LT4 covers don't even come close to interfering with guideplates.

I'm running CompCams ProMag 1.6 RRs, 7/16" studs and guideplates with no modifications to the covers.

 

I just put on a set yesterday. I have the GMPP 1.6 rockers and had no problems. They cut down the valve train noise very nicely.

 

Does anybody have the part # for the composite LT4 valve covers ?

Thanks, Adam

 

12552321 Drivers side
12552322 Passenger side
10108675 x 8 Bolt screws
10108674 x 8 Studs
12555685 New oil fill cap

Total was $201.14 shipped here to me in Hawaii from Sam Taylor Buick in Ft. Walton Beach FL. You can find a 800 # and an e-mail address if you look around on this message board. Jason Cromer is the guy to get hold of.

 

WOW!!!!!!

That was quick and complete.


Thank you very much, Adam M.

 

[QUOTE]Originally posted by craigffb
[B]12552321 Drivers side
12552322 Passenger side
10108675 x 8 Bolt screws
10108674 x 8 Studs
12555685 New oil fill cap


P.S. The bolt screws (10108675) come in a small bag of ten.

 

[QUOTE]Originally posted by carlos64030

Quote:

P.S. The bolt screws (10108675) come in a small bag of ten.

When you get them from Jason he only send 8 and that's all you get charged for.

 

hehe I got mine for free I had to mod them to fit my 1.6 Crane gold non-Self Aligning rockers.