i just saw a friend posted hes selling his lt1 edit software and computer, its off his 95 i bought from him but im building my 94, i know the harness and computers are the same but the diagnostic ports are diff, is there a way i can rewire the cord so that i can plug it into my car and tune it?
anybody have the diagram or instructions?
ive seen them before on shbox site, i tried it before when i triend the obd2 conversion, but i had no luck
any input welcome

 

http://www.akmcables.com/aldlif.jpg

 

Ick. The forum is shrinking the image into incoherence.

Right click "view image"

 

I use my cable on both OBD1 and OBD2 ports. I just soldered tiny detailing nails to the data stream and ground and then just use the two approriate two ports on either system. After two years of using it on my 94 and friends 95's. Haven't had a issue.