Lines from radiator to trans
Lines from radiator to trans
what are these two lines running past the starter?http://shbox.com/1/starter.jpg[/IMG]
Stock trans cooler
Stock trans cooler
I just installed a hayden last sat and it only cost me 42.00 . Not to hard to install and if your doing a tranny fluid change Like i did ,Thats the best time to do it. I'll find the invoice and give you the info if you want ?
Originally posted by lantern's97Z
I just installed a hayden last sat and it only cost me 42.00 . Not to hard to install and if your doing a tranny fluid change Like i did ,Thats the best time to do it. I'll find the invoice and give you the info if you want ?
I just installed a hayden last sat and it only cost me 42.00 . Not to hard to install and if your doing a tranny fluid change Like i did ,Thats the best time to do it. I'll find the invoice and give you the info if you want ?
what do you think?
ok here's the info I got the hayden cooler from www.bulkpart.com (makco) It was 34.44 plus shipping This is the heavy duty 26,000 so it will do a great job. Next go to www.bfranker.badz28.com and brent has a full page on how to install the cooler.The only other part that your gonna need is a 3/8 barbed fitting (home depot) It's like a buck.It will be a little tough getting the fitting on the factory hose but it will go. The hardest part is getting the zip ties through the other radiator. Be smart and lift the fan off the holders ( left side) and that will give you more room. Take your time and it's not that bad of a job. Good luck
An aftermarket cooler is a good idea when you have a higher stall converter in the car. A high stall produces more heat and the extra cooler gets rid of that heat.
On my car I pulled those hard tranny lines out and bought some socketless Aeroquip hose and fittings in the place of it. It cost a more for these parts, but I hate lining up the hard lines on the transmission.
On my car I pulled those hard tranny lines out and bought some socketless Aeroquip hose and fittings in the place of it. It cost a more for these parts, but I hate lining up the hard lines on the transmission.
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM
Doug Harden
Automotive News / Industry / Future Vehicle Discussion
27
Aug 22, 2002 01:47 PM



