LE2 Heads/Cam Track times inside... and I broke..
#35
Re: LE2 Heads/Cam Track times inside... and I broke..
I'm in the very NE corner, right next to Bristol. Nashville is around 4ish hours away. You'll be near FastZinTN though, watch out, he will PIITB on the first date.
#38
Re: LE2 Heads/Cam Track times inside... and I broke..
Originally Posted by Loadre
...and enjoy those low DA's while you can haha. Our shiat runs slow up here.
#40
Re: LE2 Heads/Cam Track times inside... and I broke..
Originally Posted by Loadre
Ah they're about medium. TN weather switches so much from day to day it's hit or miss. For reference Bristol Dragway is ~2000 ft elevation.
Gotta make up for that DA somehow!
I think I read the Nashville area is around 600' elevation tho.. so not that bad..
#41
Re: LE2 Heads/Cam Track times inside... and I broke..
Im going to the track tomorrow, with a da of -600 I should get some good baseline numbers. Ill be sending of my heads and intake to Lloyd and hope to see low 11's. Lloyd has been really helpful in answering my questions through email.
#42
Re: LE2 Heads/Cam Track times inside... and I broke..
Dont feel bad I had the same thing happen to my Impala! First I killed the 4l60e (input housing) then...well now I have some type of valve train problem. Have you pulled your lifters yet? I had the same thing with the spider bent but my locks were still tight one of the lifters mushroomed in the bore and took out the cam! I spend hours getting it of the the top of the motor only to find that the cam was wiped! But you gotta love it when the LE2 stuff is all fluid!
Vid of the cam: http://videos.camaroz28.com/Player.a...3-1384DFBC53C5
You should see the lifter bottom was flat and the housing cracked in two places...btw they were crane lifters. If your gonna change the lifters think about these:
http://cgi.ebay.com/ebaymotors/NEW-G...spagenameZWDVW
I like the way there cut open on the ends, just make me feel better about those step LE cam ramps. Good luck!
Jason
Tampa, FL
Vid of the cam: http://videos.camaroz28.com/Player.a...3-1384DFBC53C5
You should see the lifter bottom was flat and the housing cracked in two places...btw they were crane lifters. If your gonna change the lifters think about these:
http://cgi.ebay.com/ebaymotors/NEW-G...spagenameZWDVW
I like the way there cut open on the ends, just make me feel better about those step LE cam ramps. Good luck!
Jason
Tampa, FL
Thread
Thread Starter
Forum
Replies
Last Post
teedoff59
Car Audio and Electronics
0
08-08-2002 01:36 AM