I have a 93 Z28 and for a great deal, I am going to buy 94 JBA headers for it. I've heard that the only differences are AIR and EGR locations. Is this true? Can I make them fit in my Camaro without much trouble? If they will fit, is it harder to make the AIR and EGR fit or to just block them off completely? Which is cheaper? Has anyone done this?

thanks
John

 

If i remember the different between them is that on the passenger side, on the aft part close to the flange is a egr pipe that goes back into the intake (back). Yes you can block it off with a fab up metal plate. I have a pic in my web page of the headers (94) to take a lot at.

Vinny

 

Thanks Vinny.

Will everything else fit ok or are there any other mods needed?
Anybody

John

 

It was easy to install the driver side took about 1 hour with removal and install, the passenger side is another story that took me 5-6 hours. Everything should match up all I would say is get yourself new set of gaskets and header bolts and flange bolts. Also if you can get a extra hand would help as well. I did it by myself, and it was hard to hold the header and guide the bolts in at the same time. Also let me add if your going all out with a exhaust system and your old cats are do for some changing might as well change them also.

Vinny