whats up guys, i'm in the middle of a heads and cam install on my 94 Z...my mods are p&p heads/intake, cc306, vig 3200, csi electric water pump, hooker lts, ed wright tuning, 3.73s, and 1le delete pulley...i'll be getting it dynoed as soon as its finished and i'll post up results...any predictions on the 1/4 times and rwhp?? thanks

 

That is what I am finishing up right now. We are gonna have almost identical mods on the same year car....whenever you get it dynoed let me know how it did..I would be interested to know the outcome..

 

I'd say with good tuning you would be close to the 400 mark.

 

It will all depend on how the heads perform.

 

the man that ported my heads said they're flowing well over 260...is that good enough?

 

Not too shabby. Depends where they flow that, how turbulent the ports were, and what the low and mid-lift numbers were. All these will affect how the cam will behave in your car.

IMO, I think you'll be in the 380~390 rwhp range.

 

i'll be getting the flow sheets within the next couple days and i'll post up the numbers...hey tn94z i'll let u know how it goes at the dyno