Been hearing alot about gaskets not matching up to the jet-hots lately. and i am ordering jet-hots. What gaskets are to be used with them? I hear some peole the felpro 1406 are matching up correctly?

 

I use Fel-Pro's 1406 after my Jet-Hot supplied gaskets burnt up on me.

 

I bought a set of steel, stock replacement manifold gaskets when I did my Mac's. I'd heard of a few people using them and having good luck. Been about 2 months since I installed them, and haven't had a leak yet.

 

Felpro and 12 point ARP bolts. Used to run the Stage 8's and they were a major PITA. With the ARP's you can actually get a box wrench on every bolt.

 

where can i get the ARP bolts?

 

Summit.

 

Summit sells the copper exhaust gaskets with the lt1 d- port. I used them on my edelbrock headers and they worked perfect. I plan to use a new set with my jet hots.They were only $20 2 years ago so they can't be much more now.

 

I used Perceys Dead Soft Aluminum and absolutly love them. They match the ports perfect and do not leak. I've had them on for almost 2 years and no leak, even when I did have 1 bolt back about half way out
I'd definetly buy them again.

 

my cousin had coppers and he took them off within minutes. said they are junk and to never run copper. so felpro 1406 or aluminum?

 

I like the Felpros. I had coppers and they leaked from moment 1.

 

On my TA i am doing jet hot lts this weekend and i am using stock jethot gaskets so i will let you know what kind of problems i run in to and what i end up using. any idea what kind of quarter mile times after install??? i got a lt1 with morosso intake and flowmaster muffler and i ran a 13.5 at 102?? what about any of you with just intake and exaust what did you guys run????

 

I ran 13.80@104 with just CAI and exhaust. Never ran with the LTs on though.

 

I've run the Mr. Gasket copper w/ D-shaped ports since I got the LTs. No leaks, and I've seen them in the local Advance Auto parts.