Had my car dyno'd at a local dyno day last weekend. Was a little dissapointed, but not too bad.

Best pull was my first pull and it was 280hp and 306tq. The A/F was in the low 12s and dipping into the high 11s past 5300rpm. Mods are Jet-Hot LTs, custom y-pipe, to 3" I-pipe with a spintech pro street muffler. And a SLP cold air kit.

Was hoping for 290hp, but oh well. Best E/T has been a 13.6 @ 104 with a 2.2 60'. That about right for these numbers?

Oh yeah, here's the vid. Tell me what ya think.

https://umdrive.memphis.edu/mtfinch/public/96z.wmv

 

Focus on launching. You can do way better than 2.2 60-ft times. Get some ET streets or something and really launch that baby.

Of course you might want to have the rear end fund ready to go first just in case.

 

It's most likely the a/f ratio being off. Youre track times are very good though, so you are making good power if you're trapping 104 mph.

Dan

 

I'm gunna agree with everyone else about ur 60ft times, i had an issue with launching my LT1 car, they take some getting use to...and i'd try and get a better fuel map for ur car especially above 5k mark but very cool video, i really like ur exhaust and the car sounds pretty strong!