Double Checking my pinion angle...ASAP
Thread Starter
Registered User
Joined: May 2000
Posts: 2,889
From: Peachtree City, GA
Double Checking my pinion angle...ASAP
LOOKING from the DRIVERS SIDE.
angle on the DS is 2 to the left of the 0.
angle on the TQ arm (pinion) 1 to the left of 0.
so Pinion(1) - ds(2)= -1 pinion angle right?
So i am at -1 RIGHT?
angle on the DS is 2 to the left of the 0.
angle on the TQ arm (pinion) 1 to the left of 0.
so Pinion(1) - ds(2)= -1 pinion angle right?
So i am at -1 RIGHT?
n00b
Banned
Joined: May 2003
Posts: 6,661
From: LA (lower Alabama)
Re: Double Checking my pinion angle...ASAP
Measure your pinion off of your rear end yoke. Disconnect the drive shaft and put the yoke at 12&6 o'clock and measure the angle.Should be around 3* neg. stock.
Thread
Thread Starter
Forum
Replies
Last Post
grabbem88
LT1 Based Engine Tech
23
Mar 18, 2015 01:25 PM
squarehead
General 1967-2002 F-Body Tech
7
Jan 15, 2015 07:02 PM