DIY Cutouts?
Thread Starter
Registered User
Joined: Aug 2004
Posts: 1,388
From: SE Michigan
DIY Cutouts?
I saw some non-motorized cutouts online for like 30$ each. I was wondering If I should get them and if its possible to make my own motors to open and close them when i get a chance(Save a couple hundred bucks).
I was also wondering if i should get two or one and put it at the end of the y-pipe? Also, what size do i need for the stock y-pipe(May upgrade soon so should i get a bigger size, dont know which one yet though)?
Btw, do i have to do any welding because i don't have that equipment or do i just cut a piece of pipe and add my own?
I was also wondering if i should get two or one and put it at the end of the y-pipe? Also, what size do i need for the stock y-pipe(May upgrade soon so should i get a bigger size, dont know which one yet though)?
Btw, do i have to do any welding because i don't have that equipment or do i just cut a piece of pipe and add my own?
Last edited by pHEnomIC; Sep 10, 2004 at 08:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
tdigger9899
General 1967-2002 F-Body Tech
9
Sep 7, 2015 10:56 AM
PFYC
Supporting Vendor Group Purchases and Sales
0
May 21, 2015 01:04 PM