cc306 instal bout to start..this is what i have so far..what else do i need...
Re: cc306 instal bout to start..this is what i have so far..what else do i need...
Originally Posted by 1 Nasty Bird
Probably cause it starts pulling hard after 3K!
Re: cc306 instal bout to start..this is what i have so far..what else do i need...
Yeah it comes on around 3k for sure. Since my car has 3.23s in it still it shows up alot. If i mash the gas below 3k, say around 2k as soon as it hit 3-3500rpm it just blower the tires off of it! At the drag strip a 3500-4500rpm launch is a must.
Jeremy
Jeremy
Re: cc306 instal bout to start..this is what i have so far..what else do i need...
3k+ is sweet
exhaust note starts screaming right about that time too! Freeway speeds are fun too, crazy top end compared to stock, I can't wait to get my heads ported... Don't worry about driveability, I'm running the stock tune right now (waiting on cable...) and it's behavior is acceptable to me for stop n go.
Why'd you sell your magnaflow?! I have one and I love it! I was worried about it being too loud with no cat, but I think it sounds nice at idle, definitely hideable with a little gas if you're worried about cops. And as long as you don't rev it past 3k (BORING!) it's quiet. I understand where you're coming from though, I'm going to put those vortex cone things in after my cutout, make it more sleeper like....
exhaust note starts screaming right about that time too! Freeway speeds are fun too, crazy top end compared to stock, I can't wait to get my heads ported... Don't worry about driveability, I'm running the stock tune right now (waiting on cable...) and it's behavior is acceptable to me for stop n go. Why'd you sell your magnaflow?! I have one and I love it! I was worried about it being too loud with no cat, but I think it sounds nice at idle, definitely hideable with a little gas if you're worried about cops. And as long as you don't rev it past 3k (BORING!) it's quiet. I understand where you're coming from though, I'm going to put those vortex cone things in after my cutout, make it more sleeper like....
Thread
Thread Starter
Forum
Replies
Last Post
1996LT1Z28
Suspension, Chassis, and Brakes
4
Apr 14, 2015 07:15 PM



