13.0's with stock manifolds....anyone?
Thread Starter
Registered User
Joined: Mar 2003
Posts: 980
From: batavia, ohio
13.0's with stock manifolds....anyone?
i did!
i will have the full video up in a few days but here is the launch
this run was with the cut-out open and running on ET streets. and weld 3.5" skinnies up front. this was a 13.0 run
the car has only the mods listed below. has stock manifolds, stock suspension!!
the launch technique was to pretty much dump the clutch at 5,000 rpm and pray not to break an axle
whatcha think
BTW, this was a 1.891 60' time.
i think the car has a 12.999 in it. next, i am gonna gut the cats and put a little better clutch in and see what happens. it is gonna go on a diet too.
i will have the full video up in a few days but here is the launch
this run was with the cut-out open and running on ET streets. and weld 3.5" skinnies up front. this was a 13.0 run
the car has only the mods listed below. has stock manifolds, stock suspension!!
the launch technique was to pretty much dump the clutch at 5,000 rpm and pray not to break an axle
whatcha think
BTW, this was a 1.891 60' time.
i think the car has a 12.999 in it. next, i am gonna gut the cats and put a little better clutch in and see what happens. it is gonna go on a diet too.
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM