Procedure For LS1 Rocker Arm Install?
Thread Starter
Registered User
Joined: Nov 2003
Posts: 252
From: North Carolina
Procedure For LS1 Rocker Arm Install?
Does anyone know the procedure for installing stock rocker arms on an LS1? I thought that you just torque, rotate the motor a few times and then re-check. Now I am hearing that there is a recomended procedure to follow. Thanks
Registered User
Joined: Sep 1998
Posts: 8,319
From: US 1 Mile Marker 52 in the Florida Keys
Re: Procedure For LS1 Rocker Arm Install?
all i did was torque them down....roll the motor over a few times....recheck the torque and be done with it.
did it that way when i did my spring swap with stock rockers, and later when i installed my harland sharp rollers.
did it that way when i did my spring swap with stock rockers, and later when i installed my harland sharp rollers.
Registered User
Joined: Feb 2006
Posts: 65
From: Long Island NY
Re: Procedure For LS1 Rocker Arm Install?
Originally Posted by teke184
all i did was torque them down....roll the motor over a few times....recheck the torque and be done with it.
did it that way when i did my spring swap with stock rockers, and later when i installed my harland sharp rollers.
did it that way when i did my spring swap with stock rockers, and later when i installed my harland sharp rollers.
Do the Harland Sharp's fit under the stock V/C's or did you have to modify anything?
Registered User
Joined: Sep 1998
Posts: 8,319
From: US 1 Mile Marker 52 in the Florida Keys
Re: Procedure For LS1 Rocker Arm Install?
they were the stock 1.7 ratio...not the 1.8s.
but yes they fit.
had to use a hand file to clearance a TINY bit of the inside egde of the cylinder head, where the valve cover seals to the head.
but yes they fit.
had to use a hand file to clearance a TINY bit of the inside egde of the cylinder head, where the valve cover seals to the head.
Thread
Thread Starter
Forum
Replies
Last Post
Brandon Wittmer
General 1967-2002 F-Body Tech
0
Dec 7, 2014 12:15 PM
