Phantom Auto Meter Oil Pressure Gauge
Thread Starter
Registered User
Joined: May 2002
Posts: 231
From: royal oak, MI, USA
Phantom Auto Meter Oil Pressure Gauge
Any ideas where i can hook up the sender to the block?
------------------
Scott Parkinson
2001 Sunset Orange Z-28
SLP Loud Mouth, K&N, Mass Air, 160 Thermistat, Power Programmer, All aftermarket suspension/braces, 8.5mm Plug Wires, 125 hp Shot. Runnin low 12's all day.
------------------
Scott Parkinson
2001 Sunset Orange Z-28
SLP Loud Mouth, K&N, Mass Air, 160 Thermistat, Power Programmer, All aftermarket suspension/braces, 8.5mm Plug Wires, 125 hp Shot. Runnin low 12's all day.
Registered User
Joined: Mar 2000
Posts: 835
From: HOUSTON TX USA
In case you have not already figured this out ... 
The sender is on the right rear of the block - tucked underneath the cowl.
Note that "right rear" assumes you have the hood open & are looking towards the windshield.
I assume that it just screws in - my Haynes manual has a wonderful how to remove description of "remove sending unit located on the rear of motor - see picture."
Thanks for nothing, people !!
Britt
* D'oh ! - I got my rights & lefts confused !! *
------------------
'99 T/A
Best 13.071 @ 104.92
Now own '99 SS # 2073 !
12.969 @ 105.44
[This message has been edited by NEWBIE T/A (edited June 12, 2002).]
The sender is on the right rear of the block - tucked underneath the cowl.
Note that "right rear" assumes you have the hood open & are looking towards the windshield.
I assume that it just screws in - my Haynes manual has a wonderful how to remove description of "remove sending unit located on the rear of motor - see picture."
Thanks for nothing, people !!
Britt
* D'oh ! - I got my rights & lefts confused !! *
------------------
'99 T/A
Best 13.071 @ 104.92
Now own '99 SS # 2073 !
12.969 @ 105.44
[This message has been edited by NEWBIE T/A (edited June 12, 2002).]
Thread
Thread Starter
Forum
Replies
Last Post