I just did my first mod on my 2000 Z last night---an Edelbrock 3 point strut tower brace. I'm happy with the results. This weekeknd is mod #2!!!!! A Magnaflow catback exhaust. Does anybody know of any surprises or anything that the instruction don't tell you? Or of any fitment problems. Suspension and y-pipe are stock, and everything looks straight forward. I know my way around a garage, I just am not too big on surprises.

The catback's mid an over-axle pipes are 3' mandrel bent stainless. No flats in the bends.

 

should bolt right up...no hassles other than centering the tips...mine were off center about 2"

 

Agree...the Magnaflow install is pretty simple and straighforward. My tips lined up pretty good after a little adjustment. Definitely went better than when I put Borla on my first F-body.

 

installed mine by myself and it took about 90 minutes....most of that was getting the old system off...straight forward...great system!