LS6 manifold? casting #?
Registered User
Joined: Apr 2003
Posts: 4,507
From: FTW, TX
Re: LS6 manifold? casting #?
Those are BOTH LS1 manifolds.
Not only is the bottom not flat, but they have the X shaped bracing between the ports. An LS6 manifold has a flatter bottom and 1 verticle w 2 horizontal ribs in the area between the ports.
Here is a pic. The LS1 is on the left.
http://www.ls1howto.com/howto/geniii...//IMAGE009.jpg
Note the difference in the area between the ports and the LS1 having the bump in the middle.
Not only is the bottom not flat, but they have the X shaped bracing between the ports. An LS6 manifold has a flatter bottom and 1 verticle w 2 horizontal ribs in the area between the ports.
Here is a pic. The LS1 is on the left.
http://www.ls1howto.com/howto/geniii...//IMAGE009.jpg
Note the difference in the area between the ports and the LS1 having the bump in the middle.
Last edited by Greed4Speed; Jun 19, 2006 at 05:33 PM.
Thread Starter
Registered User
Joined: Sep 2005
Posts: 1,326
From: Tulsa, OK
Re: LS6 manifold? casting #?
Ahhhh Thanks alot guys. Its good to have this all cleared up, Bayer, you might want to add a section to the sticky about LS1 vs LS6 intakes lol. I've seen this issue many times and its difficult. If we can all get it sorted out you should add it in.
Registered User
Joined: Jan 2005
Posts: 2,592
From: N Falmouth MA
Re: LS6 manifold? casting #?
Good ****... Did and done! Thank for the info... Learn something new everyday! I added a BUTTLOAD of new stuff to the stickey... to include a section on FREE MODS....
I have to say, this has been quite educational!.... I love this place!
I have to say, this has been quite educational!.... I love this place!
Last edited by Bayer-Z28; Jun 21, 2006 at 02:45 AM.
Thread
Thread Starter
Forum
Replies
Last Post
GusarskiSS
Exhaust System
1
Sep 2, 2015 03:51 PM