Help! I just installed a torque converter in my car and now it won't start. I confirmed there is no spark. The crankshaft position sensor is above the starter which I moved but IMHO I did not put alot of stress in the wiring in that area. I also did a resistance check with the wires from the Crank sensor to the PCM and saw 1 ohm on each wire. The ignition feed voltage is wierd also. The shop manual says the value should be B+. I saw .7 Volts. Any advice would be appreciated.

 

First check and see if you have a tach signal by looking to see if you tach moves when you crank it. Otherwise it could be the cam sensor. Let me know I will try to help.

 

Dammit! The cam sensor wire was pinched between the trans and the engine. Well I'll be more careful next time